Brother TN360 Toner Installation Guidelines and Tricks

So you’ve just unwrapped a TN-360 toner your purchased a few months back, to replace your printer’s cartridge which is now blinking empty. Soon after diligently following the manufacturer’s http://www.printerinkwarehouse.com/ installation instructions, you notice that the LED light on your Brother Laser Printer’s manage panel continues to flash. Then you comprehend that it really is 12midnight, and you are rendered virtually helpless, as you have absolutely no clue how to get a replacement toner in order to print an 80 web page report that is due initial factor in the morning.

When such situations occur, a single might instinctively call a technician for diagnosis, or purchase a new toner to replace what is presumably a faulty cartridge. Although these problems are not uncommon, it really is excellent to know that most of these troubles can be rectified without having having to consult a specialist. No matter whether you’ve bought a genuine toner or an aftermarket cartridge, here’s a list of troubleshooting directions for some TN-360 installation problems:

1. Your printer’s LED light blinks constantly even right after replacing the TN-360 toner and DR-360 drum.

There will be certain instances when you could require to manually reset your printer to eliminate a blinking LED drum light. Very first, you’ll have to open your printer’s front cover. With your new drum and toner nonetheless installed, press the go button or the white button. Hold for about four seconds till your printer’s whole manage panel lights up. Close the front cover and your printer should now be prepared for use.

two. Your newly replaced laser toner cartridge is prematurely displaying as empty

If your printer’s control panel indicates an empty cartridge and you happen to be practically certain (primarily based on prior prints) that your toner is nowhere near empty, this basic trick should enable you to extend your toner’s mileage. Begin by pulling out your cartridge from your printer. You must see two holes at both side of your toner. Use an electrical tape to cover each holes and reinsert your toner cartridge. You should be able to print a couple of hundred far more tn360 toner pages and save dollars with no getting to replace your TN-360 toner.

3. Flashing Error Light

A flashing error light can be one particular of the easiest but often also the most difficult of errors to troubleshoot. If you have just installed a new TN-360 cartridge, there might be a want to clear your printer’s memory which by now is really possibly complete. Reset your printer by pressing the go button and holding it for around five seconds. Turn your printer off and on to check.

If the error persists, check for any paper jam. Inspect both the front and back panels. Don’t forget to pull out the DR-360 drum. Most paper jams take place in the drum and rear panel locations. Torn label and tape can cause serious errors and are often difficult to detect so make confident your printer is clear of any debris.

These are simple troubleshooting tips that will help you diagnose or fix some difficulties which you may possibly have with your toner or printer. If you continue to experience troubles, don’t try to discover any further as this could cause additional damage. When in doubt, don’t hesitate to call a certified printer technician.

Advertisements